This was considered a failure as the bend was not that well made, a bending tool would likely be required. In addition the metal sheet delaminated by the bend so, a composite plastic beam was inserted so the metal sheet could be screwed to it
Monday, 13 March 2023
Experiments with 90 Degree Corner Bending of Insulated Metal Panel Sheet (IMPS) for Small Low Cost Shelter
Subscribe to:
Post Comments (Atom)
We've had a flood of water that has leaked and damaged some of the hardware, electronic collectables and clothes we sell to raise funds for our project
We will let them dry out and then inspect them to see what can be salvaged
-
'Shelter and Hardware Bank Network' (SAHBN) Launch Press Release : 17/8/19 by Paul Ridley of Cabinz CIC Cabinz CIC announc...
-
Idea for sorting a mixed bucket of screws into smaller pots as relaxation & therapy Cabinz are talking and delivering screws. bost, n... -
Proposal to Create a Storage Solution to facilitate Reuse for Overfilled Garages in the UK, as an Alternative to Garden Rooms Introductio...
No comments:
Post a Comment