Sunday, 10 September 2017

Using Old Car Tyre Strips to Join Stick Frame Hexayurt Panels to Form a More Flexible Joint

 While currently building the Hexayurt with Drywall / Composite Stick Frame & Magnesium Oxide ( Mgo) Board Cladding . Re-used Insulation Infill 

I was thinking about variations on joining of the panels.

As I am re-using free bottles etc for the insulation, and given the current hurricane in Florida, I was thinking of a free & plentiful, strong flexible seam that would withstand a high wind. 

Old worn tyres came to mind.

Note. if the edge sealant does not waterproof the seam, a covering flashing (perhaps of grp sheet strips may need to be installed) ) 

After trying another method (see following pics) I think its best to:

  ( Update ) Related shelter 

 Maison Gomme is a quirky backyard shed made with recycled tires

1.  cut both sides off as per the vid below with a Contour Knife & Trimming Blade .

 

2. Then cut the tread part of the tire one with a metal bladed jig saw. This leaves a flat strip .

3. Put a bead of silicon sealant along the side of tyre or panel edge

4. screw (tyre wall screws well into metal dryall clad wood etc) or ideally bolt (stronger) each side of the tyre strip to the panel.

5. A grp tape reinforced 70mm diameter plastic bottle tube couble be placed inside the stip to act as an air filled support

 Other method I tried, if a wider strip is required ( a notorcycle tyre could also be used )

 Note: tyre does not need to be cut in half , just do one cut .

Then side wall is cut on bothe sides to allwo tyre to be spalyed out flat


Close up 
Drill tyre with metal or wood drill bit 

 Tyre wall screws well to panel

A strip of taped , air filled 70mm dia bottles  can be used as a filler

 close up in situ

Note 6mm Mgo Board bends quite a lot without breaking, (pic), so I will be making a prototype curved panel,  which wll perhaps remove the need to have a wedge shaped tre strip installed.

However a curved frame may be more labour intensive 


 

 

 

2 comments:

  1. I would like to thank you for the efforts you've put in writing this website. I am hoping to see the same high-grade blog posts from you in the future as well. In fact, your creative writing abilities has motivated me to get my own blog now ;).
    cash for cars melbourne

    ReplyDelete
  2. I recently came across your article and have been reading along. I want to express my admiration of your writing skill and ability to make readers read from the beginning to the end. I would like to read newer posts and to share my thoughts with you. car tow dublin

    ReplyDelete

More thoughts on reusing plastic bottles, waxed cuboid cartons, metal cans & cardboard, for insulation & shrapnel protection

Following on from Previous experiments by Paul Ridley reusing plastic bottles, waxed cuboid cartons & cardboard over several years, main...